+- diy-hifi-forum.eu (https://diy-hifi-forum.eu)
+-- Forum: Archiv (https://diy-hifi-forum.eu/forumdisplay.php?fid=198)
+--- Forum: Community Center (https://diy-hifi-forum.eu/forumdisplay.php?fid=7)
+---- Forum: neue Mitglieder (https://diy-hifi-forum.eu/forumdisplay.php?fid=70)
+---- Thema: New Member (/showthread.php?tid=10564)
New Member - ErikS - 07.11.2015
Hi, Audio DIY freaks, my name is Erik and I am from the Netherlands. I came up on this forum while I was looking for a design for a couple of Gradient W148/8 drivers that I would like to use in a d'appolito. I see there is a lot of knowledge here.
In the Netherlands we have only a few DIY audio forums, but I see that in Germany there is more interest in designing and building projects. Up till now I built one small 2 way monitor with a 10 cm Nova driver and a dayton tweeter. I used boxsim for a simulation because I don't have equipment to make measuers yet.
I hope to learn al lot from this forum.
Sorry for using the English language. My German writing is not very good. Reading is no problem, I can understand what you post here.
Grtz,
Erik
New Member - MOD Peter Wind - 08.11.2015
Hallo Erik,
ich denke auch wenn du in englisch schreibst wirst du hier Antworten auf mögliche Frage erhalten.
Kannst schon anfangen.
Gruß
Peter